Owners in Shivpuri are often surprised that their solar system makes its best hourly output not in May, when the sun is fiercest, but on clear, cool days in February and March. The reason is heat. Solar panels turn light into electricity, but they lose a little efficiency for every degree they warm up, and a dark panel on a Shivpuri roof in May can reach 65–70 °C. Here is what that means for your units, and how to keep the loss small.
Key Takeaways
- Panels lose about 0.3–0.4% of their power for every degree above 25 °C.
- On a 44 °C day, panel temperature can cut hourly output by 12–18%.
- May still gives high monthly units because days are long and skies are clear.
- Air gap under the panels, a shaded inverter and morning cleaning help most.
- A summer dip is normal; a sudden drop on one day is not — check it.
Light makes power, heat takes some away
A solar panel's rated power, say 540 watts, is measured in a laboratory at a cell temperature of 25 °C. Outside, the cells run much hotter than the air, because the dark glass absorbs sunlight. On a still afternoon the cells are usually 20–30 °C warmer than the air around them. In Shivpuri, where May and early June regularly see 42–45 °C, that puts the cells at 65–70 °C.
Every panel has a temperature coefficient, printed on its datasheet. For common mono-PERC panels it is around -0.35% to -0.40% per °C; newer TOPCon panels are a little better, around -0.30%. So a cell at 70 °C, 45 degrees above the test condition, loses roughly 14–18% of its power at that moment. Add some dust and the inverter warming up, and a 3 kW system that might give 2.4–2.5 kW at noon in March gives perhaps 2.0–2.2 kW at noon in late May.
So why is my May bill still low?
Because hours of sunshine matter more than peak power. In May the sun rises early, sets late and the sky is almost always clear. A 3 kW system in Shivpuri still produces about 14–15 units on a typical May day, among the highest of the year, compared with 9–11 units on a foggy January day and as low as 6–8 on a heavy monsoon day. Over the year, each kW gives about 1,450–1,500 units. The heat loss is real, but it is already built into that figure, and into the savings estimate your installer should have given you.
| Season in Shivpuri | Typical units per kW per day | What limits output |
|---|---|---|
| February–March | 4.8–5.2 | Very little — cool, clear and sunny |
| April–June | 4.6–5.0 | Heat and harvest dust |
| July–September | 2.5–3.8 | Cloud and rain |
| December–January | 3.0–3.8 | Fog, haze and a low sun |
What helps in the heat
Leave air under the panels. Panels mounted with a gap of at least 300–400 mm above the roof run several degrees cooler than panels laid close to a hot RCC slab, because air can flow behind them. Elevated structures, which many Shivpuri homes choose to keep the terrace usable, help here too.
Keep the inverter in the shade. Inverters also reduce their output when they overheat. An inverter on a west-facing wall in direct afternoon sun can cut back for an hour or two each day in May. Mount it on a shaded wall or under a canopy, with space around it for air, and keep its fan and vents free of dust.
Clean in the morning, never at noon. Harvest dust in April and May adds to the heat loss. Rinse the panels early in the morning or late in the afternoon with low-TDS water. Spraying cold water on glass at 65 °C risks stress on the panel, and hard borewell water dries into white spots in the sun.
Choose a good coefficient when you buy. If you are buying now, compare the temperature coefficient on the datasheets. A panel at -0.30% loses noticeably less than one at -0.40% over a long Shivpuri summer.
What does not help
- Covering the panels in the afternoon. Any shade cuts output far more than heat does.
- Running water over panels all day. It wastes water, leaves scale and adds little.
- Tilting panels flat for summer. A fixed tilt of about 20–25° suits Shivpuri's latitude across the year.
When a dip is not the heat
A gradual 10–15% fall in afternoon output from March to May is normal. Watch instead for a sudden drop: one day's units falling by a third in clear weather, the inverter showing an error code, output flat-lining at the same value every afternoon, or one string producing much less than the other. These point to a loose connector, a tripped breaker, an overheating inverter or a damaged panel. Note the date, take a photo of the inverter screen and call your installer.
Plan your expectations, not just your system
When you compare quotes, ask the installer for an estimate month by month rather than one yearly figure. A good estimate for Shivpuri will show strong numbers from February to May, a fall in the monsoon and a smaller one in the foggy weeks of winter. If a quote promises the March figure all year, it is overselling. Sunvera Energy builds every proposal from the district's actual sunshine and your own MPMKVVCL bills, so the savings you are shown are the savings you can expect.
Need a check?
If your system seems to be producing less than it should this summer, WhatsApp a photo of your inverter screen and your recent generation to +91 77103 07937. Our team at the Pichhore head office will tell you whether it is normal summer heat or something worth a visit, anywhere in Shivpuri district.
Frequently Asked Questions
Yes, per hour. Panels lose about 0.3–0.4% of their power for every degree above 25 °C. On a 44 °C Shivpuri day the cells can reach 65–70 °C, cutting hourly output by roughly 12–18%. Long sunny days still make May one of the best months for total units.
About 14–15 units on a typical clear May day, among the highest of the year, because days are long and skies clear. That compares with about 9–11 units on a foggy January day and 6–8 units on a heavy monsoon day.
No. Spraying cold water on hot glass at midday can stress the panel, and hard borewell water leaves white spots that block light. Clean gently early in the morning or late in the afternoon with low-TDS water instead.
On a shaded, well-ventilated wall or under a canopy, with space around it for air. An inverter in direct afternoon sun can overheat and reduce its output in May and June. Keep its fan and vents free of dust.
Get a free site survey & PM Surya Ghar subsidy guidance.


