In central India, a healthy rooftop system produces roughly 4–5 units per kW per day on clear days and about 1,450–1,500 units per kW per year. A 3 kW system should therefore make around 360–400 units a month on average. If yours is consistently well below that for the season, something — dust, shade, a tripped string or an inverter fault — needs attention.
Key Takeaways
- Expect about 4–5 units per kW per clear day; less in monsoon and winter.
- Check generation monthly against the same month's expected figure, not against summer peaks.
- The inverter display, the monitoring app and the net meter each tell part of the story.
- A sudden drop usually means a fault; a slow drop usually means dust or new shade.
- Fault codes and long periods of zero generation need the installer, not DIY.
What your system should produce
| System | Clear day | Monsoon day | Average month | Year |
|---|---|---|---|---|
| 1 kW | 4–5 units | 1.5–3 units | 120–130 | 1,450–1,500 |
| 2 kW | 8–10 | 3–6 | 240–260 | 2,900–3,000 |
| 3 kW | 12–15 | 5–9 | 360–400 | 4,300–4,500 |
| 5 kW | 20–25 | 8–15 | 600–650 | 7,200–7,500 |
| 10 kW | 40–50 | 15–30 | 1,200–1,250 | 14,500–15,000 |
March to May usually gives the best months, July and August the weakest, and winter sits in between because days are shorter. The figure in your proposal is the one to compare against.
Three places to look
- Inverter display. Shows today's units, total units since installation and the current power. A green or normal status light means it is running; a red light or error code needs a call to the installer.
- Monitoring app. Most inverters connect to Wi-Fi and show daily, monthly and yearly generation. This is the easiest way to spot a drop.
- Net meter. Shows import and export readings. It confirms what reaches the grid, but not total generation, because part of the solar energy is used directly in the house.
A five-minute monthly check
- Note the month's total units from the app or inverter.
- Compare with the same month last year, or with the proposal estimate.
- Look at a few clear days: is the daily figure near 4–5 units per kW?
- Check the net meter's export reading and the bill's import and export lines.
- Look at the panels for dust, bird droppings or leaves, and the roof for new shade.
A simple notebook or spreadsheet with these numbers makes any problem obvious within a month or two.
Reading the warning signs
| What you see | Likely cause | What to do |
|---|---|---|
| Slow decline over weeks | Dust or bird droppings | Clean with water and a soft brush in the early morning |
| Drop in the afternoon only | New shade — tree, building, tank | Trim or relocate; ask about moving panels |
| Sudden drop by a third or a half | A string tripped or a connector failed | Call the installer; do not open DC boxes yourself |
| Zero generation on a sunny day | Inverter off, grid fault or tripped breaker | Check the AC breaker; then call the installer |
| Error code on the display | Inverter detected a fault | Note the code and call the installer |
| App shows nothing but inverter is running | Wi-Fi changed or router off | Reconnect the logger to Wi-Fi |
A worked example
A family in Bilaspur has a 3 kW system. In April the app shows 410 units for the month — about 13.7 units a day, comfortably within the expected range for a clear, hot month. In June it shows 290 units, which looks worrying until they compare it with the monsoon expectation of 5–9 units on cloudy days; with a mix of sunny and rainy days, 290 is normal. In November, though, it shows only 250 units against an expected 330–360. They notice that a neighbour has added a floor on the south side, shading two panels after 2 pm in the winter sun. The installer moves those two panels to the clear northern edge of the roof, and December generation returns to normal. A monthly check found in four weeks what a bill would have hidden for a year.
Compare like with like
The most common false alarm is comparing a monsoon or winter month with an April peak. Always compare a month with the same month in a previous year, or with the month-by-month estimate in your proposal. Sunvera proposals give that estimate so customers have a fair benchmark.
Why systems underperform
The most common causes are simple: dust in dry months, new shade from a growing tree or a neighbour's new floor, a loose connector that heats and fails, a tripped breaker after a storm, or an inverter that stopped after a grid fault and did not restart. Panels themselves rarely fail; they lose only a small fraction of output each year, which warranties account for.
Cleaning — the easiest gain
In dry, dusty months, rinsing the panels with plain water and a soft brush or sponge every one to two weeks recovers lost output. Clean in the early morning when panels are cool, never with hard brushes, detergents or high-pressure jets, and never stand on the panels. In the monsoon, rain usually does the job.
When to call the installer
Call for any error code, any sudden drop, zero generation on a sunny day after checking the breaker, burning smells, damaged cables or water inside a junction box. DC wiring carries voltage whenever the sun is up, so it should only be opened by a trained technician.
Our support
Sunvera Energy sets up the monitoring app at handover and shows you what normal generation looks like for your system. If the numbers look wrong, WhatsApp a screenshot of the app or the inverter display to +91 77103 07937 and we will tell you whether it needs a visit. AMC customers get scheduled checks and generation reviews as part of the contract.
Frequently Asked Questions
About 12–15 units on a clear day in central India, 5–9 units on cloudy monsoon days, and an average of 360–400 units a month — around 4,300–4,500 units a year.
A sudden drop usually means a tripped string, a failed connector, a tripped breaker or an inverter fault. Check the AC breaker and the inverter display for error codes, then call your installer. Do not open DC boxes yourself.
Every one to two weeks in dry, dusty months, using plain water and a soft brush in the early morning. Near cement plants or busy roads, weekly cleaning may be needed. In the monsoon, rain usually keeps panels clean.
No. The net meter shows energy imported and exported. Part of the solar output is used directly in your home before reaching the meter, so total generation is shown on the inverter or monitoring app.
Get a free site survey & PM Surya Ghar subsidy guidance.

