☀ PM Surya Ghar Registered EPC
Solar Water Pump

Solar Water Pump Installation for Farms — 3 to 10 HP

A solar water pump lets a farm irrigate through every sunny hour with no diesel, no electricity bill and no waiting for night-time farm supply. Sunvera Energy supplies and installs 3, 5, 7.5 and 10 HP solar pumps — submersible for borewells, surface for open wells, ponds and canals — across Madhya Pradesh and Chhattisgarh, sized from a site survey of the water level, source yield and field. For eligible farmers, Sunvera also explains the PM-KUSUM route through MP Urja Vikas Nigam in Madhya Pradesh and CREDA in Chhattisgarh, and installs outside the scheme for farmers who prefer to buy directly.

Submersible or surface — choosing the pump type

Submersible pumps sit inside a borewell below the water level and push water up. They suit deep water — 30 m and more — and are the usual choice across the borewell-dependent belts of Shivpuri, Guna, Ashoknagar and Datia. Surface pumps sit beside an open well, pond, river or canal and pull water up through a suction pipe; they are efficient for shallow lifts of up to about 7–8 m suction and suit Balaghat's and Chhattisgarh's canal and pond irrigation. Both are driven by a solar pump controller with maximum power point tracking, dry-run protection and, on most models, remote monitoring.

Sizing table — what each pump can deliver

PumpPanel arrayMax total headWater per sunny day at 30 m headTypical farm
3 HP≈ 3 kW≈ 50–70 m≈ 1–1.5 lakh litres2–4 acres, vegetables
5 HP≈ 4.8 kW≈ 70–100 m≈ 1.8–2.5 lakh litres4–8 acres, wheat, soybean, paddy
7.5 HP≈ 6.75 kW≈ 100–150 m≈ 2.8–3.5 lakh litres8–12 acres, deep borewell
10 HP≈ 9 kW≈ 120–180 m≈ 3.8–4.5 lakh litresLarge farm, very deep bore

Figures are indicative and fall as head rises. A borewell that yields only 10,000 litres an hour cannot feed a pump rated for 30,000 — the survey measures source yield so the pump is matched to the water actually available.

What the survey measures

  1. Static and pumping water level in the borewell or well, and its seasonal drop in summer.
  2. Source yield — how much water the source gives per hour without running dry.
  3. Delivery height and pipe length to the field, tank or channel, to calculate total head.
  4. Crop and area — daily water requirement through the irrigation season.
  5. Array site — open, shade-free ground close to the source, with space for a fenced frame.

From these, Sunvera chooses the pump type and HP, the array size and the pipe diameter, and gives an expected daily water output for your site.

Running cost: diesel vs solar

5 HP diesel pump5 HP solar pump
Fuel per day (6 hrs)6–8 litres ≈ ₹150–250None
Season cost (100 days)₹15,000–25,000Near zero
MaintenanceOil, filters, overhaulsPanel cleaning, yearly check
When water is availableWhenever fuel is boughtEvery sunny hour
LifeEngine overhauls every few yearsPanels 25 years; controller and motor serviced as needed

Compared with night-time grid supply, the gain is time and safety: water comes in daylight, without trips to the field at 2 am.

PM-KUSUM and buying directly

Under PM-KUSUM Component B, eligible farmers can get a standalone solar pump with central and state assistance, paying only a defined farmer share that may be partly financed by a bank. In Madhya Pradesh the scheme is run through the MP Urja Vikas Nigam (MPUVN); in Chhattisgarh through CREDA. Shares, quotas and empanelled vendors change from year to year, so Sunvera checks the current rules on the agency portal with you before any money is paid. Farmers who are not eligible, whose district quota is exhausted, or who want a specific configuration can buy directly from Sunvera with the same survey, warranty and service. Either way, no portal or agent should charge a farmer to register.

Getting the most water from a solar pump

  • Store water by day. A tank or farm pond filled through the sunny hours lets you irrigate in the evening or with drip and sprinkler systems at lower pressure.
  • Pair with drip or sprinkler. Micro-irrigation needs less water per acre, so the same pump covers more land — useful in summer when borewell levels drop.
  • Track the sun manually or seasonally. Adjusting the array tilt twice a year, or using a manual tracking frame, adds noticeable output in the morning and evening.
  • Keep panels clean. Field dust settles quickly; a rinse every week or two in the dry season can add 10 per cent or more to daily water output.
  • Watch the water level. If the pump starts tripping on dry-run protection in May, the water level has fallen; lowering the pump in the bore restores flow.

Installation, protection and service

The array is mounted on a galvanised frame at the right tilt, fenced in isolated fields, with anti-theft fasteners. The controller is housed in a weatherproof enclosure with dry-run, over-voltage and overload protection, and the motor cable is sized for the depth. Sunvera commissions the pump, records the water output, and trains the farmer on cleaning and fault signs. Service is run from offices at Pichhore (Shivpuri), Gwalior, Balaghat and Bilaspur. Send your borewell depth, water level, field size and crop to +91 77103 07937 for a pump recommendation.

Frequently Asked Questions

Get a free site survey

Written generation estimate, exact price after subsidy and bank-finance options — no obligation.